|
Tank Removal:
7 OIL provides oil tank removal services in both the residential and commercial setting. A typical buried oil tank removal consists of the following events:
Local permits obtained at township offices
Utilities marked out prior to breaking ground
Removal of tank contents (liquid)
Uncovering and accessing the inside of the tank
Removal of residues and sludges
Removal of tank from ground
Inspection of tank and surrounding soils
(Soil Sample if Required)
Backfill to grade / Rake out surface
Recycling of tank carcass as scrap metal
Disposal of tank's contents at a permitted facility
Disposal:
7 oil can provide disposal services for certain
non-hazardous waste streams. Petroleum impacted soils can be excavated, loaded, and transported to one of our several Southern New Jersey facilities. Properly packaged drummed waste can be shipped to permitted facilities.
In order to obtain pricing and availability, a Material Profile Sheet has to be completed describing the waste at hand. Once characterized the most cost efficient facility will be chosen as a
final destination for the waste. If a
certain disposal facility is requested, we will
make every effort to gain approval into that facility.
Soil Remediation:
In the unfortunate event that a tank has leaked, certain steps are taken to effectively clean up the property.
Once a leak has been identified, the New Jersey Department of Environmental Protection must be notified. A 24 hour phone number is available to report the incident and to obtain a case number.
A memorandum of agreement (MOA) is then sent to the property owner with guidelines on choosing a contractor and remediating the incident. In some cases, the groundwater is impacted along with the surrounding soils.
There are various methods and technologies on remediation: soil and groundwater. The basic remediation is the excavation, transportation and disposal of contaminated soils along with the pumping, treatment, and disposal of
groundwater. In the event that you are
confronted with this situation, 7OIL will provide options, information, and pricing to remedy the problem.
The ultimate goal of performing remediation is
to obtain a No Further Action (NFA) letter from
the Department of Environmental Protection. Once the inspected area has been remediated to below DEP action levels, a report will be
generated for review by the DEP. Once
everything meets DEP approval, an NFA letter
will be sent to the responsible party. This effectively is the clean bill of health for the property.
Soil Sampling:
There are several scenarios where soil sampling could be required or requested:
Prior to purchase of property
After tank has been removed from ground or abandoned in place
When tank is known to have leaked
In many towns and counties, it is mandatory to obtain at least one soil sample from beneath a buried oil tank whether it is removed or abandoned.
In other cases, lending institutions, insurance companies, or property purchasers request soil samples prior to transfer of property.
All soil samples are properly collected, containerized, and delivered to a New Jersey certified labratory for analysis. When concentrations have been determined, a report
is generated detailing the findings. This documentation should be saved for future reference and/or presentation to an institution, buyer, or local or state agency.
Installation:
Many times buried or above ground oil tanks
need replacement. In some cases this is due to aging, and in other cases replacement is due to insurance companies, mortgage companies, or new purchases of property. Generally, these
tanks are 500 gallons or less in capacity, unless
the tank is in a commercial setting.
In residential settings, the tanks can be placed in several different locations. The most common is outside of the home, alongside or in the rear of
the property. Some prefer to have the tank installed in the basement or crawl space.
Yet another option is to place the tank in the garage, with impact protection posts surrounding the tank. Garage installation is sometimes
the only option in certain townhome settings.
When a new tank is installed, the old tank has to properly taken out of service by either removing the tank or abandoning the tank in place.
Abandonment in Place:
In certain situations, it may not be cost effective
or practical to remove a tank from the ground. In most townships, non-regulated heating oil tanks can be left in place and filled with a inert clean
material. Prior to this filling in place, 7 OIL performs the following:
It is recommended that soil samples be obtained from beneath the tank for future documentation.
Local permits obtained at township offices
Utilities marked out prior to breaking ground
Removal of tank contents (liquid)
Uncovering and accessing the inside of the tank
Removal of residues and sludges
Cut holes in tank bottom to gather soil samples
Inspection of tank interior by township officials
Backfill grade and rake out surface
Disposal of tank contents at a permitted facility
|